2026 Actual4Labs Huawei H35-210_V2.5 Dumps and Exam Test Engine [Q23-Q46]

2026 Actual4Labs Huawei H35-210_V2.5 Dumps and Exam Test Engine

Huawei H35-210_V2.5 DUMPS WITH REAL EXAM QUESTIONS

NEW QUESTION # 23
Which of the following methods can be used to implement communication between Ethernet switches across VLANs? (Select All that Apply)

A. When different VLANs are configured on different switches, you can configure hybrid or trunk interfaces to implement inter-VLAN communication.
B. Smart Link can be deployed on switches to implement inter-VLAN communication.
C. When different VLANs are on the same switch, you can set the IP address of the VLANIF interface to implement route forwarding.
D. You can configure MSTP on a switch to implement inter-VLAN communication.

Answer: A,C

Explanation:
Comprehensive and Detailed Step by Step Explanation:
* B (Correct): VLANIF interfaces enable Layer 3 routing between VLANs on the same switch.
* D (Correct): Hybrid/Trunk ports allow tagged traffic to pass between switches.
* A (Incorrect): Smart Link provides link redundancy, not inter-VLAN routing.

NEW QUESTION # 24
Is the following description correct? In the EPON network, in order to avoid data conflicts and improve network utilization efficiency, the downstream direction adopts TDMA multiple access mode and arbitrates the data transmission of each ONU.

A. False
B. True

Answer: A

NEW QUESTION # 25
In the GPON network, which one of the following descriptions is correct?

A. Different ONUs are identified by Port-ID
B. Different GEM-PORTs are identified by Alloc-ID
C. Different T-CONTs are identified by Port-ID
D. Different ONUs are identified by ONU ID

Answer: D

NEW QUESTION # 26
What fax modes are supported in UA5000?

A. T38 fax method
B. Transparent transmission method
C. Instantaneous one-way mode
D. Interactive fax mode

Answer: A,B

NEW QUESTION # 27
Regarding MA5600 Super Vlan and Sub Vlan, which of the following descriptions are correct?

A. Super VLAN is mainly used to save IP addresses
B. Sub VLAN types can be: Smart VLAN, MUX VLAN, Standard VLAN.
C. Super VLAN is different from VLAN in the usual sense. It is just a Layer 3 interface and does not contain physical ports.
D. Sub VLAN only contains physical ports, and a three-layer VLAN virtual interface can be established.

Answer: A,C

NEW QUESTION # 28
What kind of remote acceptance function does not support MA5600T/MA5680T?

A. FTP simulation test
B. BTV simulation test
C. DHCP simulation test
D. Voice call simulation test

Answer: A

NEW QUESTION # 29
PVM packet voice processing board, which manages and controls the narrowband user board in the UA5000 chassis. What are its main functions?

A. Support the encapsulation of TDM voice into IP packets upstream to the softswitch equipment
B. Support encapsulating TDM voice into ATM cell upstream to softswitch equipment
C. Support the TDM voice signal upstream to the switch through the V5 interface
D. Realize V5 protocol and H.248/MGCP protocol processing

Answer: A,C,D

NEW QUESTION # 30
Is the following description correct? The computer in the local area network judges whether the received broadcast frame is what it should receive is to judge the source of the frameMACIs the address the same as the hardware address of the machine .

A. False
B. True

Answer: A

NEW QUESTION # 31
Is the following description correct? Users can establish PVC connections between different board ports or between different ports on the same board. The main purpose is to realize the point-to-point interconnection between two different users.

A. False
B. True

Answer: B

NEW QUESTION # 32
Which of the following access network products can provide ADSL access methods?

A. MA5100
B. UA5000
C. MA5600
D. MA5300

Answer: A,B,C,D

NEW QUESTION # 33
ADSL G.992.1 (G.dmt) is a technical specification that does not require a signal splitter.

A. FALSE
B. TRUE

Answer: A

NEW QUESTION # 34
What are the management protocols running between the OLT and the ONT in the GPON network?

A. OAM
B. HGMP
C. DHCP
D. OMCI

Answer: D

NEW QUESTION # 35
Which of the following protocols are included in Point-to-Point Protocol (PPP)? (Select All that Apply)

A. ICMP
B. IGMP
C. Network control protocol (NCP)
D. Link control protocol (LCP)

Answer: C,D

NEW QUESTION # 36
What is the maximum splitting ratio supported by the MA5680T GPBC board?

A. 1:32
B. 1:16
C. 1:128
D. 1:64

Answer: D

NEW QUESTION # 37
Which command is used to delete a single board in the UA5000 chassis?

A. Board erase
B. Undo board
C. Board delete
D. No board

Answer: C

NEW QUESTION # 38
Which of the following statements about ATM network VP and VC is correct?

A. A VP can include multiple VCs;
B. There is no logical connection between VP and VC.
C. VPI occupies the same number of bits in all cells, and the same is true for VCI;
D. A VC can include multiple VPs;

Answer: A

NEW QUESTION # 39
The customer needs to access the following information points: AP, PC, IP camera, and IPTV. The AP is powered by the ONU. The types of ONU interfaces include:

A. GE, GE (PoE)
B. GE, GE (PoE), Wi-Fi
C. GE, GE (PoE), POTS
D. GE, GE (PoE), RF

Answer: B

Explanation:
* GE (PoE): Powers the AP.
* GE: Connects to PC, IP camera, and IPTV.

NEW QUESTION # 40
IPMB is the broadband control board of UA5000. What are its main functions?

A. Used to converge and process broadband services (ADSL, VDSL, SHDSL, LAN)
B. Forward the VoIP service of the PVM single board, and realize the IP uplink through the FE or GE interface.
C. Supports multicast services and can provide dedicated multicast channels.
D. Provide broadband switching resources, have dual-system hot backup function, and support active/standby switchover.

Answer: A,B,C,D

NEW QUESTION # 41
Which of the following methods can be used to test the reset of an OLT board?

A. Press the RESET button on the control board handle to forcibly reset the control board, and check whether the board works properly after reset.
B. Hot swap the board and check whether the board works properly after reset.
C. Run the board reset command to reset a service board, and check whether the service board works properly after being reset.
D. All of the above

Answer: D

Explanation:
* Testing Board Reset :
* Testing the reset functionality of an OLT board ensures that the board can recover from failures or configuration changes.
* Methods for Testing Reset :
* Hot Swap : Physically removing and reinserting the board tests its ability to initialize and function after a reset.
* RESET Button : Pressing the physical RESET button on the board forces a hardware reset, verifying recovery capabilities.
* Reset Command : Using CLI commands (e.g., reset board) resets the board remotely, allowing verification of software-based recovery.
* Why D?
* All three methods are valid ways to test the reset functionality of an OLT board. Each method addresses different scenarios and ensures comprehensive testing.
Thus, the correct answer is D .
References:
* HCIA Huawei ACCESS Official Documentation , Chapter: OLT Maintenance.
* OLT Hardware and Software Reset Procedures by Huawei.

NEW QUESTION # 42
When carrying services, the GEM port needs to map services to the T-CONT units for upstream service scheduling. Each ONU supports multiple T-CONTs, and different types of T-CONTs can be selected for different service types.

A. TRUE
B. FALSE

Answer: A

NEW QUESTION # 43
During DHCP packet forwarding, a DHCP relay agent modifies the corresponding fields in a DHCP packet to complete packet type conversion. Which of the following statements is correct?

A. The DHCP relay agent converts non-Ethernet packets into Ethernet packets.
B. The DHCP relay agent transparently transmits unicast packets without changing the packets.
C. The DHCP relay agent converts only broadcast packets into unicast packets.
D. The DHCP relay agent converts received broadcast packets into unicast packets, and vice versa.

Answer: D

Explanation:
* DHCP Relay Agent Functionality :
* A DHCP relay agent forwards DHCP packets between clients and servers located in different subnets.
* It modifies the packet headers to ensure proper delivery:
* Converts broadcast packets from clients into unicast packets to forward them to the DHCP server.
* Converts unicast responses from the DHCP server back into broadcast packets for delivery to clients.
* Why C?
* The DHCP relay agent performs bidirectional conversion between broadcast and unicast packets to facilitate communication between clients and servers in different subnets.
* Other Options :
* A : Incorrect because DHCP relay agents do not convert packet types (e.g., Ethernet vs. non- Ethernet).
* B : Incorrect because the relay agent handles both broadcast-to-unicast and unicast-to-broadcast conversions.
* D : Incorrect because the relay agent modifies unicast packets during forwarding.
Thus, the correct answer is C .
References:
* HCIA Huawei ACCESS Official Documentation , Chapter: DHCP Relay Agent.
* RFC 2131: DHCP Protocol Specification .

NEW QUESTION # 44
If the type of the GPON optical module is Class C+, the receiver sensitivity is:

A. -32 dBm
B. 7 dBm
C. 3 dBm
D. -12 dBm

Answer: A

NEW QUESTION # 45
Is the following description correct? When the ONT is offline, the MA5600T/MA5680T can perform ONT PPPoE simulation test operations.