Online Questions - Valid Practice H12-891_V1.0 Exam Dumps Test Questions [Q153-Q171]

Share

Online Questions - Valid Practice H12-891_V1.0 Exam Dumps Test Questions

100% Real H12-891_V1.0 dumps  - Brilliant H12-891_V1.0 Exam Questions PDF


The written exam covers theoretical knowledge of data communication network design and implementation, including network architecture, network protocols, network security, network virtualization, and network management. The lab exam tests the candidate's ability to configure and troubleshoot complex data communication networks using Huawei products and solutions. The interview is designed to assess the candidate's communication skills, professional ethics, and overall understanding of the industry.

 

NEW QUESTION # 153
Which of the following are used in Ethernet?

  • A. 8025 encapsulated frames
  • B. Mac address in canonical format
  • C. CSMA/CD in multiplexed interviews
  • D. 8023 Encapsulated Frame
  • E. A MAC address in a non-canonical format

Answer: B,C,D


NEW QUESTION # 154
The correct statement about the difference between OSPFv2 and OSPFv3 is ? Multi-select

  • A. OSPFv3 is similar to OSPFv2 in that it uses a multicast address as the OSPF message destination address
  • B. BOTH OSPFv2 and OSPFv3 support interface authentication. And OSPFv3 authentication is still based on the fields in the ospf message header
  • C. The same type of message exists in OSPFv2, OSPFv3: Hello, DD, LSR, LSU, LSAack, Their message format is the same
  • D. OSPFv2 has the protocol number 89 in the IPv4 packet header, OSPFv 3 The next number in the IPv6 message header is 89

Answer: A,C,D


NEW QUESTION # 155
What is the wrong description of the function of OSPFv3 protocol authentication?

  • A. Huawei router OSPFv3 IPSec authentication can not only support transmission mode, but also support tunnel mode
  • B. The OSPFv3 protocol header removes the Type and Automation fields
  • C. OSPFv3 can only establish a security alliance SA using manual mode
  • D. OSPFv3 authentication relies on IPv6 packet authentication headers and encapsulation security net load headers

Answer: A


NEW QUESTION # 156
In an MPLS BGPVPN networking that does not enable MPLS penultimate hop pop-up technology. When the message reaches the last hop PE, the message has two layers of labels, and the two layers of label values can be the same.

  • A. FALSE
  • B. TRUE

Answer: B


NEW QUESTION # 157
Regarding the mpLS handling mode of TTL, is the following description correct?

  • A. In MPLSVPI, if you need to hide the structure of the MPLS backbone network, you can use Uniform mode on Ingress for private network messages .
  • B. Unifore style, when an IP packet passes through the MPLS network, the IPTTL of the incoming node is minus l. The MPLS TTL field is a fixed value.
  • C. The TTL in the MPLS label has the same meaning as the TTL field in the head. TTL prevents mpLS networks from developing bad routing.
  • D. Pipe mode. When an IP message passes through the MPLS network, the IPTTL minus 1 is mapped to the WLSTTL field at the incoming node.

Answer: C


NEW QUESTION # 158
What are the following statements about 8021x, RADIUS, and HWTACACS certification? ( Multiple choice questions).

  • A. RADIUS authentication is mutually exclusive with 8021x authentication.
  • B. RADIUS authentication and HWTACACS authentication can perform two-factor authentication for the same user at the same time, which is more secure.
  • C. RADIUS authentication and WTACACS authentication are mutually exclusive and cannot be two-factor authentication for the same user at the same time.
  • D. Users can use 8021x authentication to access the network and complete identity authentication through RADIUS

Answer: C,D


NEW QUESTION # 159
What are the characteristics of Syslog information?

  • A. The transmission of Syslog messages is not acknowledgable
  • B. The transmission of Sysiog messages is reliable
  • C. The transmission of Syslog messages is unreliable
  • D. The transmission of Syslog messages is not secure
  • E. The transmission of Syslog messages is confirmable
  • F. The transmission of Syslog messages is secure

Answer: A,C,D


NEW QUESTION # 160
In VXLAN scenarios, what features can be turned on to reduce flooding of ARP messages between VTEPs?( Multiple select).

  • A. Host Information Collection
  • B. ARP broadcast suppression
  • C. port isolation
  • D. Local ARP agent

Answer: B,D


NEW QUESTION # 161
Which levels are common in the OSI reference model and the ICP/IP model? ( Multiple choice question)

  • A. Data link layer
  • B. Physical Layer
  • C. Session layer
  • D. Transmission layer
  • E. Presentation Layer
  • F. Application Layer

Answer: D,F


NEW QUESTION # 162
Regarding the FTP protocol, which of the descriptions below is correct?

  • A. FTP always uses TCP port 20 to establish a data session, and ICP port 21 to establish control will always use
  • B. In FTP Passive mode, the client completes the initialization of the TCP session for control and data
  • C. FTP TCP port 21 to establish a data session, TCP port 20 to establish a control session
  • D. In FTP Active mode, the server tells the client which port it expects to send data on by commanding "PORT"
  • E. FTP always uses a TCP session to transmit control information and data information

Answer: B


NEW QUESTION # 163
There is an As-path-filter.ip as-path-filter 1 permit*(100l400) $, which As-path-filter can match which of the following AS_PATH Attribute?( Confirmed).

  • A. 300 4200
  • B. 0
  • C. 1234 1400
  • D. 1

Answer: B,C,D


NEW QUESTION # 164
In a network, the same gigabit running S and OSPF anti-tampering and fluttering as shown in the figure, on the two border routers RTB and RTC are introduced into the wine route, the device question is to use gigabit one port strobe, , 222 The network is introduced into the OSE via impotrote direct on the RTD, assuming that all other configurations are dead default configurations, then the description of this network is wrong ?

  • A. On the RTC, the following configuration is adopted, only the routes of the 2222/32 cinder segment can be filtered out when routing is introduced, IRTClip ip-prefix 10 index 1 deny2000 8 less-equal 32
  • B. The following configuration can filter out the routes of the 2/32 CIDR block of the white RTD when RTC introduces OSPF routes.
  • C. RTB learns that the routing next hop for the 2/32 network segment is RTA
  • D. Adjusting the ISIS priority to 160 on the RTB avoids suboptimal routing problems in the network.

Answer: A


NEW QUESTION # 165
The switch role in the stacking system does not include ?

  • A. Standby Switch
  • B. From the switch
  • C. Candidate Switch
  • D. Primary Switch

Answer: C


NEW QUESTION # 166
By default, which of the following security MAC address types lose table entries after the device restarts?

  • A. Black hole MAC address
  • B. Secure static MAC address
  • C. Sticty MAC address
  • D. Secure dynamic MAC address

Answer: D


NEW QUESTION # 167
You want to set the DSCP value of VolP traffic in HW network devices to EF. According to the differentiated service model RFC, traffic token EF should be set to:

  • A. IP Experimental ECN
  • B. DSCP is set to decimal 36
  • C. IP ToS is set to OXEF
  • D. Bitstream 101110
  • E. DSCP is set to decimal 5

Answer: D


NEW QUESTION # 168
Huawei's two switches SWA and SWB are connected together by 7 Ethernet cables, and static link clustering is configured, and the corresponding port on the switch SWA is Ethernet 1/0/1 ?Ethernet1/0/2?Ethernet
1/0/3?Ethernet 1/0/4?Ethernet 1/0/5, Ethernet1/0/6, Ethernet 1/0/7, configured in order of port if the switch SWA, SWB supports only 6 ports per aggregation group

  • A. With the same configuration of each port, the Ethernet 1/0/7 port is the aggregate group Unselecte port
  • B. In the case of consistent configuration of each port, the Ethernet1/0/1 port is an aggregate group Unselected port
  • C. In the case of consistent configuration of each port, Ethernet 1/0/6 port is an aggregate group Unselected port
  • D. With the same configuration of each port, SWA randomly selects one of the 7 ports as the aggregate group Unselecte port

Answer: A


NEW QUESTION # 169
If the OSPF protocol is running in the network, after configuring the non-osseous thousand region in the OSPF region as the Totally Stub region, the ABR router sends a message to Totally The Stub area issues an LSA with an LSID of 0000, which category the LSA belongs to LSA?( Single choice questions).

  • A. LSA3
  • B. LSA1
  • C. LSA5
  • D. LSA2

Answer: A


NEW QUESTION # 170
Regarding the domain-authentication-mode md5 hello command in the ISIS process, the correct explanation is
?

  • A. All router domain authentication methods of the same routing domain are MD5, the password is hello, and lS-IS SNP and LSP will spread normally.
  • B. This command is mainly used to make is the ISIS Hello message carry authentication information during the transmission process.
  • C. ISIS authentication cannot be applied in IPv6 environments.
  • D. outing domain authentication is primarily used to allow level-1 and Level-2 SNP and LSP messages to carry authentication information during delivery.

Answer: A


NEW QUESTION # 171
......

H12-891_V1.0 Exam PDF [2024] Tests Free Updated Today with Correct 610 Questions: https://www.actual4labs.com/Huawei/H12-891_V1.0-actual-exam-dumps.html

Huawei H12-891_V1.0 Exam Preparation Guide and PDF Download: https://drive.google.com/open?id=13qyf2YqAGK2gyjJHfY2XoeHI4lNsjtjR

Contact Us

If you have any question please leave me your email address, we will reply and send email to you in 12 hours.

Our Working Time: ( GMT 0:00-15:00 )
From Monday to Saturday

Support: Contact now