Use Real NSE7_SDW-6.4 Dumps - Fortinet Correct Answers updated on 2021
NSE 7 Network Security Architect NSE7_SDW-6.4 Exam Practice Dumps
NEW QUESTION 17
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. VPN static routes are prevented from populating the FortiGate routing table.
- B. There are separate virtual interfaces for each dial-up client.
- C. 100.64.3.1 is one of the remote IP address that comes through index interface 1.
- D. FortiGate created a single IPsec virtual interface that is shared by all clients.
Answer: C,D
NEW QUESTION 18
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager
- B. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- C. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager
- D. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices
Answer: A,B
NEW QUESTION 19
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Interface-based shaping mode
- B. Per-IP shaping mode
- C. Reverse policy shaping mode
- D. Shared policy shaping mode
Answer: A
NEW QUESTION 20
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Configure the IKE mode to be aggressive mode.
- B. Use different proposals are used between the interfaces.
- C. Specify a unique peer ID for each dial-up VPN interface.
- D. Use unique Diffie Hellman groups on each VPN interface.
Answer: B,D
NEW QUESTION 21
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers. The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links. One link has random jitter and latency issues, and is based on a wireless connection.
Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD-WAN rules? (Choose two.)
- A. Configure an SD-WAN rule to load balance all traffic without VoIP.
- B. Place the troublesome link at the top of the interface preference list.
- C. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
- D. Choose the suitable interface based on the interface cost and weight.
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: C,E
NEW QUESTION 22
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)
- A. The implicit rule overrides all other rules because parameters widely cover sources and destinations.
- B. The initial session of an application goes through a learning phase in order to apply the correct rule
- C. SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom
- D. The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces
Answer: A,B
NEW QUESTION 23
Refer to exhibits.
Exhibit A.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output Based on the exhibits, which statement is correct?
- A. SD-WAN member interfaces are affected by the SLA state of the inactive interface
- B. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- C. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- D. Both SD-WAN member interfaces have used separate SLA targets.
Answer: D
NEW QUESTION 24
Refer to exhibits.
Exhibit B.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic however inbound traffic is not being evaluated by the shaping policy Based on the exhibit, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic'?
- A. The guaranteed-10mbps option must be selected as the per-IP shaper option
- B. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- C. The guaranteed-10mbps option must be selected as the reverse shaper option.
- D. The reverse shaper option must be enabled and a traffic shaper must be selected
Answer: C
NEW QUESTION 25
Which statement reflects how BGP tags work with SD-WAN rules?
- A. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- B. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- C. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
Answer: A
NEW QUESTION 26
Which statement reflects how BGP tags work with SD-WAN rules?
- A. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- B. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- C. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
- D. BGP tags match the SD-WAN rule based on the order that these rules were installed.
Answer: B
NEW QUESTION 27
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It ensures route tags match the SD-WAN rule based on the rule order
- D. It tags each route and references the tag in the routing table.
Answer: C
NEW QUESTION 28
What is the lnkmtd process responsible for?
- A. Flushing route tags addresses
- B. Monitoring links for any bandwidth saturation
- C. Logging interface quality information
- D. Processing performance SLA probes
Answer: B
NEW QUESTION 29
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. The protected subnets should be set to address object to all (0.0 .0. o/o).
- B. ADVPN should only be enabled on unmanaged FortiGate devices.
- C. On the hub VPN, only the device needs additional phase one sett
- D. Each VPN device has a unique pre-shared key configured separately on phase one
Answer: D
NEW QUESTION 30
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?
- A. Choose the suitable interface based on the interface cost and weight
- B. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule
- C. Place the troublesome link at the top of the interface preference list.
- D. Configure an SD-WAN rule to load balance all traffic without VoIP
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: A,E
NEW QUESTION 31
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?
- A. Configure an SD-WAN rule to load balance all traffic without VoIP.
- B. Place the troublesome link at the top of the interface preference list.
- C. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
- D. Choose the suitable interface based on the interface cost and weight.
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: C,E
NEW QUESTION 32
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. The protected subnets should be set to address object to all (0.0 .0. o/o).
- B. ADVPN should only be enabled on unmanaged FortiGate devices.
- C. On the hub VPN, only the device needs additional phase one sett
- D. Each VPN device has a unique pre-shared key configured separately on phase one
Answer: D
NEW QUESTION 33
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)
- A. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- B. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
- C. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- D. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
Answer: B,D
Explanation:
Explanation/Reference:
NEW QUESTION 34
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. The guaranteed-10mbps option must be selected as the per-IP shaper option
- B. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- C. The guaranteed-10mbps option must be selected as the reverse shaper option.
- D. The reverse shaper option must be enabled and a traffic shaper must be selected
Answer: C
NEW QUESTION 35
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set cost 15.
- B. Set source 100.64.1.1.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set priority 10.
Answer: B
NEW QUESTION 36
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set cost 15.
- B. Set source 100.64.1.1.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set priority 10.
Answer: B
NEW QUESTION 37
What is the lnkmtd process responsible for?
- A. Logging interface quality information
- B. Monitoring links for any bandwidth saturation
- C. Flushing route tags addresses
- D. Processing performance SLA probes
Answer: A
NEW QUESTION 38
Which components make up the secure SD-WAN solution?
- A. Application, antivirus, and URL, and SSL inspection
- B. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- C. Datacenter, branch offices, and public cloud
- D. Telephone, ISDN, and telecom network.
Answer: A
NEW QUESTION 39
Which statement is correct about the SD-WAN and ADVPN?
- A. Dynamic VPN is not supported as an SD-Wan interface.
- B. Spoke support dynamic VPN as a static interface.
- C. ADVPN interface can be a member of SD-WAN interface.
- D. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
Answer: A
NEW QUESTION 40
Which components make up the secure SD-WAN solution?
- A. Application, antivirus, and URL, and SSL inspection
- B. Datacenter, branch offices, and public cloud
- C. Telephone, ISDN, and telecom network.
- D. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
Answer: D
NEW QUESTION 41
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. The packet exceeded the configured bandwidth and was dropped based on the priority configuration
- B. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
- C. Packets exceeding the configured concurrent connection limit are dropped based on tfte priority configuration.
- D. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
Answer: C
NEW QUESTION 42
......
Get ready to pass the NSE7_SDW-6.4 Exam right now using our NSE 7 Network Security Architect Exam Package: https://www.actual4labs.com/Fortinet/NSE7_SDW-6.4-actual-exam-dumps.html
NSE7_SDW-6.4 Premium Files Test pdf - Free Dumps Collection: https://drive.google.com/open?id=1ke_NJFxeuqicObNzq2S1cNEHK7EREbMQ